troubles with 478 mounting.

[cold.nut]

what are the hole combos for the back plate that fit socket 478? i can't get it to fit what so ever!

[k|ngp|n]

Originally Posted by cold.nut

what are the hole combos for the back plate that fit socket 478? i can't get it to fit what so ever!

Sorry, currently the pots don't support socket 478 There was never any demand for it.
775 is close for top hold down...here whats u can do. Just dont use the backplate and use the 775 mounting holes in top hold down, it should work. You can make a simple plate yourself for backside and just washer/nut the rods so they "catch' on the back of mobo. You can do this without even using a backplate too, but I'd recomend it. dont fully tight the rods on it so they are a little sloppy and wont bed when you use top holdown 775 mounting. Keep us updated how it goes man..

[Hondacity]

I use a smaller pot for 478 benching. and using a clamp to sandwich the board and container

here's my setup
http://hwbot.org/submission/2217881_...dram_299.1_mhz