kingpincooling.com

Go Back   kingpincooling.com > Overclocking & Modding > Shamino's Lair

Shamino's Lair The master himself, Shamino.

Reply
 
Thread Tools Search this Thread Display Modes
  #161  
Old 09-08-2010, 11:49 PM
Viss's Avatar
Viss Viss is offline
PURE
 
Join Date: Aug 2009
Location: NL
Posts: 209
Send a message via MSN to Viss
Default

CBB mod is for booting colder, chips wil stil have their CB. Even with my chip that doenst have a CB i have to boot at -140 or so, colder = no go.
__________________
Bart
Reply With Quote
  #162  
Old 09-09-2010, 02:19 AM
Raja@ASUS Raja@ASUS is offline
Dry Ice
 
Join Date: Sep 2009
Posts: 288
Default

Quote:
Originally Posted by ZenEffect View Post
where can i snag a beta of this new bios w/ clock skew?
You won't need clock skew as most of these boards have dual clocks generators. As far as i know the skew setting on these boards will offset both clockgens by the same value, which defeats the purpose of skewing one domain against the other.
Reply With Quote
  #163  
Old 09-11-2010, 12:23 PM
ZenEffect ZenEffect is offline
Sub-Ambient
 
Join Date: Jan 2010
Posts: 64
Default

Quote:
Originally Posted by Raja View Post
You won't need clock skew as most of these boards have dual clocks generators. As far as i know the skew setting on these boards will offset both clockgens by the same value, which defeats the purpose of skewing one domain against the other.
i suppose but it also is supposed to contain better turbo mode control... one thing that i never touched on because the lack of being able to manipulate the multi's resulted in lower frequency than with them off.

either way... i still want the bios.
Reply With Quote
  #164  
Old 10-02-2010, 03:34 PM
Mack4033 Mack4033 is offline
Sub-Ambient
 
Join Date: Mar 2010
Location: USA
Posts: 50
Default

This was my old bios set up now I have the A70 Bios and changes were made I need some in put in the following...
CPU Skew Control 0ps
Clock Gen switch Mode
CPU PWM Frequency: 1189KHz
VTT PWM Frequency: 634KHz
DDR PWM Frequency: 634KHz
CPU Signal 1: Less
CPU Signal 3: -31
CPU Signal 4: -31
CPU PCIE 1/2: Auto
DDR Signal 1/2/3: Auto
DMI Signal: -31
PCH Signal -31

Case; Corsair Obsidian 800 D




Current as of 10/02/10
EVGA P55FTW MOTHERBOARD BIOS TEMPLATE
Bios Version: 08.00.16
Build Date: 10/02/10
ID: 1E657A56

Corsair Power Supply 1000 HX 1000 Watt
Video Card 2 GTX 480's in SLI

Water Cooling System Information

FANS: 3 Black ULTRA KAZE 120mm fans moving 133.60 CFM OF AIR
Pump;Swiftech MCP655 12 VDC Pump
Lines 1/2 Custom Made
Radiator; Swiftech "Stackable" series radiators 1 MCR320-QP stack mounted inside the top my Corsair Obsidian 800 D with 3 Black ULTRA KAZE 120mm fans moving 133.60 CFM OF AIR out the top of the computer case.
Fan Controller; Aero Cool
Reservoir; RAD-Reservoir Clear Acrylic Design
Coolant; Distilled Water
UV Reactive Dye; Feser UV Green Dye
CPU Cooling Block; Swiftech CPU Block 775 that is one reason why I got the P55 FTW
*More custom cooling; I made a custom fan shroud to pull more air out of the back of the case

As of 3/8/10
2 SSD Vertex 60GB in Raid 0
New i-7 870
Prod Code: BX8060517870
MM# 903875
FPO/Batch# L926B294T


Ram Perfect Storm 2133 I have oced to 2300 but not stable, it will run from 2266-2299 8-8-8 24 but 7-7-7-24 as of 2/15/10

Dummy O.C : [Disabled]
Target CPU Frequency : 4.800
Target Memory Frequency : 2022
CPU Multiplier Setting : (22)
CPU Frequency Setting : [209]
PCIE Frequency Setting : [106]
QPI Frequency Selection : [4.2700 GT/s]
MCH Strap : [1867]
Extreme Cooling : []
EVGA VDroop Control : [Without Vdroop]
Bootup CPU Vcore : [1.45V]
Eventual CPU Vcore : [1.58.8V]
DIMM Voltage : [1.66V]
Bootup CPU VTT : [1.45V]
Eventual CPU VTT : [1.475V]
Current PCH Voltage : 1.20V
PCH : [1.225V]
CPU PLL : [1.95v]
DIMM 1/2 DQ Vref : [+0 mv]
DIMM 3/4 DQ Vref : [+0 mv]
DIMM 1/2 CA Vref : [+0 mv]
DIMM 3/4 CA Vref : [+0 mv]
CPU PWM Frequency : [1867 Khz]
VTT PWM Frequency : [634 Khz]
DDR PWM Frequency : [634 Khz]
CPU Signal 1 : [Auto]
CPU Signal 3 : [Auto]
CPU Signal 4 : [Auto]
CPU PCIE 1 : [Auto]
CPU PCIE 2 : [Auto]
DDR Signal 1 : [Auto]
DDR Signal 2 : [Auto]
DDR Signal 3 : [Auto]
DMI Signal : [Auto]
PCH Signal : [Auto]
*Memory Configure*
DRAM SPD : [Standard]
DRAM Frequency : [1333 Mhz (2:10)]
Target Memory Frequency : 2022 mhz
DRAM tCL : [7]
DRAM tRCD :[7]
DRAM tRP : [7]
DRAM tRAS : [24]
DRAM tRFC : [Auto]
DRAM tRRD : [Auto]
DRAM tFAW : [Auto]
DRAM tRTP : [Auto]
DRAM tWR : [Auto]
DRAM tWTR : [Auto]
Command Rate : [2)]
Back to Back CAS Delay : [Auto]
CHA Round Trip Latency : [Auto]
CHB Round Trip Latency : [Auto]
Memory Low Gap : [] Auto
Memory Remap Feature : [Enabled]
PCI MMIO Allocation : 4GB To 1024MB
Memory Hole : [Disabled]
DRAM Margin Ranks : [Disabled]
*CPU Configuration*
Hardware Prefetcher : [Enabled]
Adjacent Cache Line Prefetch : [Enabled]
MPS and ACPI MADT ordering : [Modern Ordering]
Max CPUID Value Limit : [Disabled]
Intel (R) Virtualization Tech : [Enabled]
Execute-Disable Bit Capability : [Enabled]
Intel (R) HT Technology : [Enabled]
Active Processor Cores : [All]
A20M : [Disabled]
C1E Support : [Disable]
Intel (R) SpeedStep (tm) tech : [Disable]
Intel (R) C-STATE tech : [Disabled]

Thanks,
Mack4033

<message edited by mack4033 on 0 mins. ago>
Reply With Quote
  #165  
Old 12-30-2010, 04:38 PM
posershadow posershadow is offline
Ambient
 
Join Date: Nov 2010
Posts: 1
Default

Quote:
Originally Posted by Beaux View Post
I had issues with my first go at the p55 200.. Did the cbb mod and it does run up to -180c but I get a d3 boot error no matter what at anything above -140c so it may have been the chip or the mod was acting weird... I'll have to confirm later with a different chip.. But yeah, it seems that everytime I changed a setting in the bios it had to turn off.. Kind of a bummer..
Weird, I'm getting the same thing as you now. Stalls at d3 continuously.
Reply With Quote
  #166  
Old 01-13-2011, 11:03 PM
XtremeCuztoms's Avatar
XtremeCuztoms XtremeCuztoms is offline
PURE
 
Join Date: Dec 2010
Location: Farmington, MI
Posts: 232
Send a message via MSN to XtremeCuztoms Send a message via Skype™ to XtremeCuztoms
Default

thread bump....

great info here. got my 1st Evga board.. e659
replaced a p55a-ud6

only running chilled air cooling right now but will run some dice soon on this i5 750
thanks for the great info
Reply With Quote
  #167  
Old 10-23-2015, 09:18 AM
Bassplayer Bassplayer is offline
Sub-Zero
 
Join Date: May 2011
Posts: 112
Default

Any chance at getting some of the photos in the OP restored? I just got an E659 yesterday and it has a LOT of BIOS settings.

EDIT: Link to A58 BIOS in the OP is dead as well. Anyone have it?

Last edited by Bassplayer; 10-23-2015 at 09:39 AM.
Reply With Quote
  #168  
Old 10-28-2015, 12:07 PM
Bassplayer Bassplayer is offline
Sub-Zero
 
Join Date: May 2011
Posts: 112
Default

Searched around a lot trying to find the old images and no luck. Sent Shammy a message on FB but I'd honestly be surprised if he still has them.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:56 PM.

Contact Us - www.kingpincooling.com - Archive - Top
Powered by vBulletin® Version 3.8.3 Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.