View Single Post
  #3  
Old 04-10-2013, 12:20 AM
S_A_V's Avatar
S_A_V S_A_V is offline
Ambient
 
Join Date: Jul 2010
Location: St.-Petersburg, Russia
Posts: 14
Send a message via ICQ to S_A_V
Default

thanks for posting useful info
pin 2 of NCP does not traces to some of "small PCB" contacts (corner near C190 label)?
if it traces, then may be it is more easy (if possible) to cut it somewhere else?
in the place where ALERT signal goes from "small PCB" to main PCB or by removing some zero-resistance smd bridge resistor (if present).
__________________
Reply With Quote